New owner/Questions

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

oh2tahoe

New Member
Joined
Sep 12, 2007
Messages
26
Reaction score
0
Hey, New owner but i posted in the milage thread. I was wondering if you can run a jumper wire from the blinker lights to the Daytime Running Lights and make them both be on at the same time? I have the full white lights kit and was wondering if this is possible?
 

JKmotorsports

tahoeyukonforum.com
Joined
Jul 5, 2007
Messages
2,654
Reaction score
3
Location
ATX
Seems possible if you go to the BCM and catch the DRL and parking light wires, using a diode to isolate the circuits. I'll post with the colors and locations later tonight.
 

oh2tahoe

New Member
Joined
Sep 12, 2007
Messages
26
Reaction score
0
Alright, Thanks for the help. I know on a previous vehicle i could be done by that but i didnt know about this one.
 

JKmotorsports

tahoeyukonforum.com
Joined
Jul 5, 2007
Messages
2,654
Reaction score
3
Location
ATX
DRL relay control- Brown conn, pin A11, lt. green/blk wire
Parking lamp relay control- Lt blue conn, pin A5, white wire

These connectors are at the BCM underneath the steering column. It will have three connectors facing towards the rear of the truck. You can access them w/out removing the underdash panel.

Be sure to use a diode in series with the jumper to isolate the two circuits.
 
Top