gator101
New Member
Hello all, I am new here but I still need help with my 98 Tahoe. A month ago I was driving down the road when my vent tube came of o my transmission- 4L60E with NP 243 transfer case. When it come off somehow the hose got tangled up in the wiring to my transfer case and ripped all the wires to everything. O2 sensors, transfer case, transmission etc. Got it home while in limp mode on the transmission, when got it home the shifter cable was broken and zero oil pressure. While looking under the truck I almost lost my mind... All the wiring was wrapped around the front driveshaft. I started by dis engaging all the wires that were wrapped up and trying to see what caused the mess. I went to a salvage yard and picked up a pig tail to connect the transmission. Once I did this, and got most of the connections redone there was a few that I couldn't figure out... 3 o2 sensor connectors aren't connected and a plug to the transfer case with 6 wires. I was then pegged with the oil pressure switch, zero oil pressure. I was thinking that they are all connected but I don't know about where I need to start. I just got done putting the new shifter cable back in and cranked up again with still no oil pressure and the transfer case is stuck in 4 wheel drive. I really need help cause can't drive my truck or should I say my wife doesn't like my camaro and I have to take her to and from work. Thanks in advance for any help...
Gator
Gator
