Disclaimer: Links on this page pointing
to Amazon, eBay and other sites may include affiliate code. If you click them and
make a purchase, we may earn a small commission.
Install was pretty easy. Just remove the door panel, set the pod in place, drill holes, cut clearance for the speaker, screw in place, install speakers, jam. The hardest part was getting the d@mn door panel off.
I used the original speaker wire for the woofer, just spliced into it. I also disconnected the factory tweeter. I'm not sure if it was necessary, just thinking that the impedance would drop too low if they were all hooked up.
They sound great, depending on what type of speakers you put in them. They are stiffer than the door panel, so you can throw just about anything you want at them, and they'll take it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.