Recent content by aweber

Well, The symptoms where just not doing it for me when it came to the fuel pressure regulator, seemed to intermittent. So I can a ground from the battery to the frame and sure enough, 65PSI now... So, Moral of the story, make sure your grounds are good before fawking around with the pump...

Well, new pump and filter still getting 10PSI Fuel Pressure Regulator?

Finally got myself a fuel pressure tester. I am only getting 10 PSI. Gonna change the Fuel Filter first and go from there to fuel pump.

About 200,000 Kms - Fuel Pump is less than 1 year old, new plastic lines at the same time. Not sure if the Fuel Filter was ever changed though.

Yah, before it died I was driving at hwy speeds, the engine died for about 2 seconds then caught again running fine, then died completely 10 minutes later... The hard starts came about about 1 month before it died completely.

I don't but I will borrow/buy one next to check pressure as a next step. Do the fuel pressure regulators ever go bad on these things?

I have a 97 Yukon which stopped running on me while driving. When I spray starting fluid in the TB, it will run, but quit when I stop spraying. Because of this, I assumed fuel pump, but after checking, I can hear the Fuel Pump relay click when I turn on the key, I can see that the Fuel Pump is...

Just found the old box and yes, you are right on the money :)

Not anymore, he cross referenced it using the OEM GM part #...

I took apart the switch and the inside was all burned and corroded. I replaced it and it has been fine since. I was able to get one at NAPA pretty cheap...

OK, I just got around to looking at this again, Been pretty busy... I took apart the dash and found a nice surprise. Looks to me like the blower motor went at one point and burned the wires and connector at the switch. They just duct taped the switch and connector together and put it back...

Hey I recently purchased an 97 Yukon SLT. When I first got it, Only high speed on the fan setting would work reliably, and the rest of the fan speed would work intermittently. Next, I lost high as well. From reading on the boards, I thought to replace the blower resister, which I did...