Ill be in Knoxville with my 99 Yukon on Wednesday for a week. I am looking to get bearings redone in my rear diff. You guys have any recommended mechanics?
Hey everyone. I am wanting to replace the front windshield on my Yukon because the seals around it are beginning to rot and the glass is filled with tiny chips everywhere reducing visibility when in direct sunlight.
Anyone have a preferred brand of replacement glass? Does it really matter...
Hey Guys. I blew off my ski/snowboard rack while pulling into an underground parking lot like a dumbass the other day. Surprisingly the ski rack is fine but it broke the crossbar off my roof.
What I am looking for is a replacement crossbar that will slide into the side rails on my Denali. Im...
My Yukon is doing this too at 192k. It just started doing it this summer though.
What I have noticed though is that it does it more when my truck warms up or is driven for an hour in city traffic. From a cold start, it seems to do it less. Do you guy notice the same thing?
We are...
I am having this problem as well. I just replaced my u joints and greased the spline. About a week or 200 miles later the bump bump and noise is back when stopping and starting from a stop. So I have 2 questions:
1) Would it be possible that i just need to re-grease the spline? If so, why...
I too am having the same issue. Does anyone know where to get cheap replacement catalytic converters for our trucks?
For those of you that have already had them replaced, what did you pay for your replacements?
I think i will pull my driveshaft this weekend and take it to a shop to have the u-joints replaced. I see this as an inexpensive starting point. While the truck is up on stands, ill check drum too. After pulling the wheel off, does the drum just come free off the lugs?
Bilstiens. I had them replaced at abot 110k with some "el cheapo" monroes and really couldn't tell the difference. That is just me though. Can anyone else comment on this?
BTW, replacement bilsteins were priced for em at like $500 wheras i got a set of 4 monroes for a tad over 100. Any i...
So i ventured out to buy a floor jack and some jackstands today. I got home, jacked up the yukon and wheeled under it to see what I could find. It appears that the u-joints on the front and back of the drive shaft are ok. THere isnt any play in them and not really any rust.
That said. I was...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.