when i first put my system in i removed those plastic flappy things that are behind the caps cuz when the bass hit they rattled bad. i covered the holes with dynamat and that stopped the rattling. i think those things are for releasing built up cabin pressure like when you slam the doors with...
the amp has 3 power wires going to it. one to the battery one to a chassis ground and the other which is normally a thinner wire than the ohter two is the remote turn on. it is probably labeled REM on the amp. your friend could have used any color of wire to this connection but if you just...
i have been looking into getting the notorious black bear tune for my tahoe and found on another forum that justin will be in my area in may 09. i figured id post the link to that forum here incase anyone is near pittsburgh and wants tuned up. the location and everything is in there...
it will work i did it on my 02.
take the dash trim off to excess the headlight switch. pop the switch assembly out to get to the wires behind it. i took a dc meter to find the fog light 12v wire. then i found the 12v wire when the auto lamps are on (took a towel to cover the sensor on the...
i have a 2/4 drop and when i had 22x9.5s i ran 305-40-22. i wanted 45 series but the 40s where instock. no rubbin either. i like the 305s it makes a nice wide foot print.
yukonjacks, if you allow the resin to fully cure you shouldnt have any trouble with cracking. i didnt want to wrap it with fiberglass mat or anything cuz i didnt want to jepordize the oem fit. i only used a thin layer of filler, its just like any other part on a car if used properly you wont...
i block sanded with 80 til smooth then went over it again with 220. i filled a couple pin holes with body icing. finally primer, 3 coats of filler primer and there it is.... SMOOTH AS EGGS!! just needs painted. this whole process cost less than $50 and they turned out great. you couldnt tell the...
after the resin hardened up a bit i took a look at the front of the cap and you can see where the resin was nice and thick like i wanted. you can see toward the upper right of the slots needed a little more
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.