Recent content by catfish

thats normal for one to turn. if the one that turned with the engine were to be stopped, the other side will take over. its a limited slip differential. your axle assessment sounds logical. loose wheel could very well be bearings are bad. not too hard to do. lot easier and cheaper than the...

try the bearings in the output shaft of the tranny and at the input shaft into the rear-end. grab hold of the drive shaft and wiggle. look to see if theres any play at either. i had same problem and it was the pinion bearing in rear-end. i did it myself but be VERY careful of the parts you...

hi all. im all too new to this forum, but i have had this problem for awhile and i think its time to fix it. my temp gauge doesnt move. stays at 9 o'clock position. check gauges light stays on. ive had the dash out and cleaned the contacts. no luck. its like theres a short back there. should i...