Recent content by JDFabworks

  1. JDFabworks

    95 2dr cranks but no start

    Yes. I go to start truck and it does not crank, no ticking, nothing. Then the next turn of the key it could crank over and fire right up like nothing was wrong. Battery is good and fully charged . I have fuel and spark. So I am assuming it is ignition related or ?
  2. JDFabworks

    95 2dr cranks but no start

    Ok, now that I fixed the battery issue I am having another starting issue. I now get nothing when turning key. The dash lights come on when I turn key but nothing when trying to turn over truck. I wiggle key, turn back to ACC, radio comes on fine, etc.. Turn key 5+more times and it starts fine...
  3. JDFabworks

    95 2dr cranks but no start

    This morning I came out to the truck to find a dead battery. I noticed my vanity light was on all weekend. So jumped the truck. It would only crank over. It never fired up. It tried to fire a couple times but wouldn't stay running for more than a second. I have fuel. I didn't have time to check...
  4. JDFabworks

    95 Tahoe 2dr brake issue

    I've noticed lately driving my tahoe that when braking, I hear a whooshing air noise from firewall area under dash. Within the last few days, it has happened when hitting brakes hard and I can hear the air noise constant when my foot stays on the brakes. Also, the brakes are stiff if that makes...
  5. JDFabworks

    95 winch bumper fab

    I'll PM you.
  6. JDFabworks

    95 winch bumper fab

    Yes, $500 painted/installed.
  7. JDFabworks

    95 SES light

    Ok, so I checked my codes today. It was a code 32, EGR circuit. What avenue should I take to tackle this issue? The truck runs fine, I have no issues. Although I do need to fix exhaust leak at muffler. Pao did a poor job of putting in a new turbo muffler.
  8. JDFabworks

    95 SES light

    No, I haven't tried to get codes yet. So I will let you know what I do find.
  9. JDFabworks

    95 winch bumper fab

    I am also going to start on my rear swingaway bumper with tire carrier, Hi-Lift mount and jerrycan mount soon. I'm just in the middle of finshing a customers rear winch bumper now. My personal projects take a back seat.
  10. JDFabworks

    95 winch bumper fab

    I could build them like this, with winch mount and D-ring shackle mounts for $500. I don't know what shipping would cost you though. If there were enough demand for them I could look into shipping/truck freight costs.
  11. JDFabworks

    95 SES light

    Yeah, I know how to get codes. My issue is when I get home or wherever, shut truck off and SES light resets and goes away. So I can't get codes...... when I turn key on its normal.
  12. JDFabworks

    95 winch bumper fab

    Here's the bumper finished
  13. JDFabworks

    95 SES light

    My 95 2dr 4wd SES light comes on periodically when driving around 45mph+. Previous owner tried telling me it was a wheel speed sensor???...... Problem is when I stop and shut off truck, it resets and is off. Until I get up to that speed range again. So its tough to diagnose the SES problem... I...
  14. JDFabworks

    need help with no heat: 96 tahoe

    Ok, thanks. I'll try and check my diverter also. Is it a pain to get to behind dash or not too bad? I assume I need to pop glovebox out to get to the cover? Again, excuse my ignorance...
  15. JDFabworks

    need help with no heat: 96 tahoe

    Well, my actuator works fine (one near gas pedal). But still don't get flow velocity in forward vents when putting dial in that position. I removed vac line from heater control valve under hood and I got heat through defrost and defrost/feet. So, I assume my solenoid may be bad then?
Top