Recent content by kevhill85

Thank you

Ok finally had time to work on the Tahoe . Cut the floor and made room for the drive shaft Drilled and tapped the the head for a mech temp gauge. You see in the next two photo how much the rear was narrowed .

Today i mocked up the DRods fuel cell into my 2dr Tahoe .. I pick this cell from TxStVanWilder Friday and it fit great.. Here what left to do so the fuel cell fit the way I need to .. Cut about 2 3/4 off the back side of the mounting tab Add some rubber cushion between the frame and cell...

Here where I am at on the motor rebuilded. For the stall I went with a revmaxx 2600 stall.. I figure use the lt 4l60e and a stall untill it blow and then go with a 4l80e

Ok some more updates ARP studs installed Rods and pistion assy Frame horns lowwered

Here a photo of my trick at ride hieght.. I hope the front I'll about one inch lowwer with the motor in place.

Ok time for update and photos .. I hope to order the ls1 383 stroker kit next week.. New mounts /// Dirty Dingo 5.3 ls1 block borded out to a 3.905 New cam bearing install Order a PSI wiring harness.. Very nice piece of work All so bought a 3 inch narrowed rear end from a...

With he new frame the Tahoe body dropped 6 inch My plans 1) 4link truck so I can keep back seat 2) install ls1 347 stroker / 4l60e 3) redone the to all black 4) remove all bags 5) make it more a prostreet truck 6) coil over the rear 7) install a 6lug 10bolt narrowed 3inch 8) whatever else I...