Recent content by KILLROY

Thanks!

- remove the trim piece that covers the Torx screws that secure the light, remove the screws and gently pull the taillight assembly out. I had to use a pair of pliers just a bit of force to get the reverse light connector to rotate and extract from the housing - but then the bulb was a quick...

The airbox is easy, how about drilling holes in the sealed covers so you can run the wiring. My setup you have to actually cut the headlight wires and feed them through the included grommet and solder to the included wire assy. Not my definition of plug & play.

Plug n Play? My low beams are in sealed compartments and the right one is behind the air cleaner assy. Is there a trick to this Im not aware of?