Recent content by tofargone

I put about 1/3 in through the brake booster line and the rest in the tank. It worked instantly and smoked like hell.

Did it on my 98, really smoothed out the idle. Little more power, but mainly in the idle.

Does the shaking go away if you take your foot off the gas? Also is your steering loose or tight?

Are you sure its in the front end or tires. Mine did this under load and it was in the motor. Changed a lot of the ignition parts and the problem has been gone for a while. Do you throw any codes?

Sounds like it could be a short. Is the motor cutting out or is it stuttering out?

Put 1/3 through the brake booster vacume line and the rest in the gas tank. Also changed the plug wires and the vibration has been gone for the last three days. I'll give it a couple of weeks before I celebrate, but I'm crossing my fingers its licked. Next step is to clean the throttle body...

I checked the mounts and they are all tight and not cracked, and the tires are new, I had the tech look over the rims prior ( it did it before new tires) and he said they were fine. I just seafoamed it yesterday ( man was that cool ) and put new plug wires on also. I didn't have the...

I am about a day away from lighting a match and watching the damn thing burn. I have a 98 hoe with 140K. I bought it with 136K about 3 months ago. When I bought it I had a bad shake when holding a speed between 45 and 60 going up a steep hill. I also threw a code for a random misfire...

Mine did the same thing, replaced the pulse module good as new. I would try it, it takes about 5 minutes to do and only cost about 20-30$

May be off base, but I had a hell of a vibration in my truck up hill at about 50-60mph. Turned out to be the exhaust had a little play in it where the cat hooks to the manifold at the three bolt flange. Replaced the gaskets and no more vibration.

Had the same issue on my 98. I started pulling wires and found that a few of them had a tiny bit of corosion that made the connection to the distributer flutter especially when the motor was really working. Cleaned them all up made sure they were snug, reset the code and no problems since...

I hate AC, what a pain in the arse to fix. So here is my issue. I have 3 leaks on my AC lines that run to the rear air. The cost of the parts from the dealer ( only place I could find it ) is $650.00. What I am wondering is since it's a straight shot along the frame could I just splice in...

I was wrong, there are donut gaskets in between the flange. I thought there wasn't since mine was gone. $13.95 fix

Looks like it does not have a gasket. Thanks

I have gone through my parts manual and called a few of the auto parts stores and no one seems to know. On the 3 bolt flange between the Cat and the manifold I am assuming there is a gasket. Does anybody know what the gasket is. The Haynes manual I have doesn't show it. My exhaust looks...