Search results

No, there is no warranty on the gearing that does up to 150,000Km

Taken care of Lester...:waytogo:

Anyone wanting upgraded rotors and pads should check out the R1Concepts options. There simply is not a better value out there with the same level of quality the parts. Check out the link in my signature and I will be happy to answer any questions... For ALL 07+ models, look up the parts for...

It could be one or the other or both. It could be a combination of the fuel pump going out as well as the cats being clogged. Yes, they can be clogged. When the engine is cold, the ECM runs the engine while not receiving information from the O2 sensors because they have to be warm to provide...

Welcome to the forum! Let's see some pics!

You're right there, I have looked everywhere and talked to everyone I know that I thought would know and I guess they have some secret formula...lol

When ordering shocks, you should be able to let them know about the ride height changes so that they can order the correct part numbers. IF I can be of any further help with finding the right parts, let me know.

Welcome! Yes, I agree with the body control module. Check the relays and wiring leading to and from the body control module. It is located under the dash behind the dash panel under the steering wheel. If the wiring looks good around it then the module is probably bad and needs replaced...

IMHO, the best choice, like stated above is a hydroboost upgrade. I personally run R1Concepts premium cross drilled and slotted rotors with Posi Quiet ceramic pads and have put them through the ringer on my 03 Duramax hauling some ridiculously heavy loads. Before installing them I was changing...

Welcome! Check the fuses, harness and connectors, but I would have to bet that you will be replacing the module itself. Let us know what you find out...

Welcome! Great looking mods. X2 on the wood floor, that is slick indeed. Nice work!

Welcome! Let's see some pics of your rig...

Welcome! Show us that Hoe!

Welcome! If the fuses are good and everything else fails. Have you possibly cleaned the engine bay lately or happen to have gone through some severe rain with standing water? It is quite possible that there is moisture in the wiring harness leading from the ECM to the body control module and...

He meant that the bushing went bad and as a result there was play where it meets the control arm or that the ball joint popped loose from the control arm altogether. Either of these issues will usually result in a popping or thud-bumping while driving down the road whether turning or not...

Yeah man, keep us posted...

Great! thanks again for sharing! Keep us updated on future mods! But how about some pics of her?

Welcome! It sounds like a wire got pinched during the installation of the tranny, if you are certain it is a short and not the sending unit itself. Whether it is still pinched by it at this point or not, I would inspect every part of any wiring anywhere around the tranny but especially where...

Welcome! I don't think it would work, but I could be mistaken. Doesn't yours have the little step between the second row leading to the third row?

The P0410 code refers to the emissions system. The AIR pump puts air to the exhaust to lower emissions. It takes in outside air and pumps it through two one-way check valves into each bank of the exhaust. About 90% of the time that this code is set, the one-way check valves have worn out or...