2007 LT
Had an intermittent warning and light for a long time until it was finally on all the time. Google searches didn't seem to have convincing info. A friend has HP tuner program which we used to gather and read all the stock programming and ERROR CODES.
One code : C0045 left rear speed...
07 LT Tahoe
Sun roof rubber seal has broken away from the glass.
Q: After loosening the rubber piece that slips into the groove each side that hides the arms, is it just a matter of removing the 2 fasteners each side and then lifting the glass up and out.
Are there 2 or 3 each side or...
I have an 07 Tahoe LT with the factory power mirrors.
Does anyone know if the OE power plug to the mirror has additional contacts/wires for heat, turn signal or other?
Looking at Ksource tow mirrors, for an 8' wide trailer that have the added functions.
Thanks for your input
o7 Tahoe park assist needs service. Dealer said it was left sensor , so i replaced it. still not working. finally decided to get 4 new off ebay with the exact same # as mine was. Took bumper cover off,replaced all 4. still not working. displays service park assist. In reverse the red light only...
Service park assist ..HELP PLEASE
So here's my 07 Tahoe scenario.
About mid winter it flashed service on the DIC
Thought it was snow accumulation because that fixed it the first time so I thought.
Now with clear roads and clean sensor lenses:
Start engine put in reverse, red light at back...
2007 LT
Readout just came on the other day for whatever reason?
What might be the likely cause?
I have an 80 lb Black Lab that often rides on the passengers seat without his seatbelt!
:help:
does an OBD2 reader work on these vehicles?
Does anyone have experience/opinions on the Eibach lowering spring kit # 38106.540 2" front 3" rear.
keeping stock tire size on 20":smiley-face-popcorn
Success!
Reinstall the door panel with the knowledge you have gained.
The next three doors are easy.
Polypropelene cones are far superior to the elements than what was there.
Enjoy!!!
Make note of the A & B terminal position (polarity is marked) of the stock connector (back view of speaker assembly.
The fun begins! Using the utility knife cut around the outer foam edge of the speaker cone, tight against the ABS. Flip the speaker over and un-solder the wire from the outer...
Starting at the lower back corner using the medium screw driver and your fingers, pop and pull the panel trim away from the frame as you work your way across the bottom & up the sides. There are a couple push pins holding the inner sound fabric (white) which can be removed so the fabric remains...
Thanks to this site, someone informed me where to find the critical removal points
What follows is how I reused the stock mounting enclosure in my process of working on a very limited budget to replace a speaker that wasn't working. Please don't laugh at what I used. :Whoa: It sounds tons...
This exersise was done because one of the speakers was not working.
Investigation determined a bad speaker.
Buget was very limited so please don't laugh at the new ones :Whoa:
Sounds much better than what was there!
I've provided some details to make it easier for someone else to access...
wanting to install
electric brake controller.
found the red lead from engine bay
WHERE IS the front(starting point) for the blue lead located?
Your help is appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.