(2006 Yukon Denali XL) I am new to the forum. I wanted to ask if anyone has any problems when using Belltech Drop Spindles and lowering the torsion bars some.
I purchased 2" drop spindles. I have already lowered the front by cranking down the torsion bars, but found running 24" the ball joints, pitmin arm and steering linkages all began to quickly show signs of wear.
No replacing all that is worn and installing drop spindles but 2" from stock is not enough.
So if I do drop it more does anyone have any rubbing problems while driving. I know clearance while turning is not an issue.
Thanks!
Keith
I purchased 2" drop spindles. I have already lowered the front by cranking down the torsion bars, but found running 24" the ball joints, pitmin arm and steering linkages all began to quickly show signs of wear.
No replacing all that is worn and installing drop spindles but 2" from stock is not enough.
So if I do drop it more does anyone have any rubbing problems while driving. I know clearance while turning is not an issue.
Thanks!
Keith
