Recent content by NASTY GM

HELP! My key fob(s) are acting up. They work while I'm in my truck. When I exit my truck they work for about 5 -10 seconds. Then they no longer work until I put the key in the door handle. It's like it goes to sleep or forgets it. Any ideas!!!

I roll 26's as well. I have the 5.3 engine with stock brakes and drive mine everyday without any problems. Due to mine being low I had to cut and trim the inner plastic fender wells but no one notices. I have never payed attention to gas milage, so I can't comment on that. It sounds like you...

Not sure for those subs. I'm running the RF Power 1500 amp to three 12" JL Audio W3's. I have the amp turned way down due to my truck rattling like a tin can :lol:

Correct :thumbsup: I bought Belltech 2" front spindles and 4" rear springs. Instead of buying 1" front springs I just cut 1/4 of a coil off the stock front springs. Perfect height for 26's. I'll try again to post some pics :crazy:

Bro I'm still trying to figure out how to post them :crazy:

Ya 2/3 will rub with 26's and even a little with 24's. I'm 3/4 and it rubbed pretty bad. I cut and trimmed the plastic inner pieces. Now I have just a little rubbing. I can handle a little rubbing for looks :D Go spindles! They ride much better than springs.

Those are the same shocks I have, so you don't have air ride.

I went from stock 17's to 26's :eek2: I have never had a problem with the ABS or anything else for that matter.

I replaced mine along with all the interior bulbs. I can't remember the brand but I bought them off craigslist. They match my HID's :cool:

I believe there's a size difference and color. What color are they?

I have Flowmaster 40 series dumped. I set off a lot of car alarms :smilielol:

Any kit with spindles. Spindles ride much nicer than springs.

26's :p

I have HID's and a high powered stereo system. I just replaced the stock battery with a Optima yellow top. You might want to just start with replacing the crappy factory battery.

I wish I would have went air ride. I have 26's and lowered with Bell Tech 2" spindles and cut a 1/4 of a stock coil off. The rear is lowered with Bell Tech 4" springs. I trimmed a lot of the plastic inner fender wells. I still have a little rubbing, but it's just plastic. The ride is not bad...