From what I have read about the front shaft is when you lift it the angles get bad and you have to buy a double cardon shaft. If not you will have vibrations if you use 4 high over 35 miles an hour.
I know this is a bad pic but you can see where I cut it and then welded it back on. As you can see there are no brackets to mod and if you make a bracket it won't fit to give you any support.
I went with rear Add A Leafs and it raised my rear up almost 3 inches because the thing is heavy as hell in the back and the springs were sagging a little. I then just cranked the torsion bars until it was level. I actually have the front higher now than what my pic shows.
Where the frame mounts to the bumper I went back a couple pf inches and cut them off then raised both sides 3 inches and welded it back on. I couldn't find a way to make brackets to raise the bumper up so that was my only choice. Trust me I didn't want to do it at first but couldn't find a...
I have a 3 inch body lift on my 98 4-door and 33x12.50 fits just fine. I had to cut the end of my rear frame and raise it 3 inches and weld it back on to raise the rear bumper. Now all I have to do is buy a rollpan hitch and then the reciever will be up where it belongs.
I have a 98 4 dorr hoe with a 3" body lift and 33x12.50 17s. I have plenty of room to even put 35s on it. I have researched the different torsion bar keys and I have been told that on OBS trucks it doesn't do any good. We have enough adjustment with the stock keys. You just have to get an...
I have a 3" body lift on a 98 Tahoe and I want to get the K&N cold air induction. Has anyone done this and what mods do I need to do? I thought about a throttle body spacer but K&N doesn't recommend that. They say I have to modify the kit but they won't tell me how because it voids the warranty.
How many leaf springs come stock on a '98 tahoe 4x4? Also how can you prevent axle wrap without ladder bars or the B.S. helper springs you see for sale that are bent really weird?
How many leaf springs come stock on a '98 tahoe 4x4? Also how can you prevent axle wrap without ladder bars or the B.S. helper springs you see for sale that are bent really weird?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.