I was acting like a jerk doing donuts in the snow tonight. I lost my power steering and brakes. I checked everything over and noticed that my power steering pulley is walking off the pump shaft. Either that or the shaft is broken. It looks as if there is no keyway and that it is pressed on. How...
Does anyone know where I can find just a passenger front AVS Ventshade for my 04 Yukon? I need to replace a broken one. I already checked Ebay and all they sell is full sets. I also emailed AVS/Lund but haven't heard back yet.
I don't think so. Maybe one setting above all the way down. It's weird because I was trying to watch my rear wiper squirts work one day so I had my dad push the button with the key on engine off. He pushed the cruise button a couple times by accident thinking it was the squirts and the cruise...
If it's on the driver's side, that's normal. Not sure if it's a brake line or not but it has a rubber conduit around it and it hangs a little low. I've noticed it on every Yukon and Tahoe in the same position.
Yup. We did that with my cousin's 5.0 mustang as well since he had failed emissions. We seafoamed it and nothing more and it actually passed the second time.
Usually it's grimy on the outside of the throttle plate. A lot of oiled filters such as K&N will allow a fine mist of oil to coat the throttle plate or the intake manifold especially if they are over oiled when cleaned. It's not a huge deal but it can impede performance if the throtle linkage is...
I'm not sure how the fitting works. The tool is designed to push up into the housing that contains the clips/connector. It should disengage it so you can pull them apart but it's easier said than done. At least the tool is made of metal and doesn't break from all the fiddle f*cking around! I...
It's a major pain even with the right tool. acccess to the filter isn't bad at all. It's those gay clips they have holding it on. It took me about 10 minutes of screwing with that tool to get it off. My truck only had 50K and the fuel on the inlet side of the filter was black. there's a pic in...
From what I've seen underneath, the stock piping is adequate in diameter. I would think replacing just the muffler would change the tone. I've been looking at the Flowmaster kit with the two tips swept to the sides and the 50 series muffler. 180 is a smokin deal if that's the same kit installed...
I just changed the fuel filter on my 04 Yukon Flex fuel. What a pain in the rear! I bought the fancy tool to release the stupid clips and followed the directions exactly. The directions should just say: Insert tool into fuel line fitting, then dick around for like ten minutes until the fitting...
I'd invest in a sun shade and some ventshades for the windows. The ventshades will allow air to circulate through the interior. I used to live in Albuquerque and my first day in NM my dash cracked on my car. It was from the cold dry air in the winter. Window tint will also help preserve the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.