Distributer Problem

[96ProCompTahoe]

Managed to get the cap and rotor wet on the way home yesterday. (sh!tty design...) after 10 minutes of choice words and dealing with the cold rain and wind... finally got the cap off, but the two screws in the rotor are rusted horribly, im afraid the T20 threads in them are just going to strip out.

any suggestions to get them out so i can put on the new rotor? don't want to get stuck at work, especially in this craptastic weather.

if all else fails i'll get the dremel tool out and cut slots in them for a flathead screwdriver. that'll be the last resort, don't want to risk getting metal shavings down in the distributor if thers an easier way.

 

[mygreen98]

did you spay any penatrating spray on them to loosen them up? wrap a rag under the rotor around the shaft before you use the dremel to keep the filling out of dist. can you get a vise grip on the screw heads?