MrMorganUSC
New Member
I found a few thread about where to run the power wire for an amp but didn't see anything that helped too much. I saw where wrenchguy said something about a groment to the right of the break fluid box. I didn't see anything. i stuck my hand back there and felt something that could work but I need to unscrew and move that box out of the way....is that necessary? I don't want to drill a hole so if someone can tell me and post a pic of where you went through your firewall that would be great.
Also.....when running power wire in other vehicles i have owned i usually just unscrew the plastic strip between the seat and the door and run it under there down the drivers side. Well i was looking at it today and it looks like you have to take the drivers seat out in order to take that piece of plastic out to run a power wire. Am I missing something here?
Amp is going under rear seat.....someone help me
Scott
Also.....when running power wire in other vehicles i have owned i usually just unscrew the plastic strip between the seat and the door and run it under there down the drivers side. Well i was looking at it today and it looks like you have to take the drivers seat out in order to take that piece of plastic out to run a power wire. Am I missing something here?
Amp is going under rear seat.....someone help me
Scott