Eric137
New Member
Just put 24" Gianelle Steep-6's on my '07 Tahoe; Tires are Pirelli 305-35-24 Scorpions....Have ZERO intention of lowering her, and didn't think there would be any rubbing issues, since the overall height of the combo is so close to stock (WRONG!)......This combo is obviously wider than stock, so I used a heat gun to reshape the plastic liner in the wheel wells....took about 15 minutes total, and had to reshape areas in front and back of each wheel.....no biggie, just wanted to pass along how easy it is to do...
HERE'S THE IMPORTANT PART:
When heating the front part of the driver's side front wheel well liner, use caution as there is a fluid reservoir directly behind it!!! I had about 1/4" to play with , which was enough to give the necessary clearance.....
Good luck!
HERE'S THE IMPORTANT PART:
When heating the front part of the driver's side front wheel well liner, use caution as there is a fluid reservoir directly behind it!!! I had about 1/4" to play with , which was enough to give the necessary clearance.....
Good luck!