Sorry for the delays. I appreciate everyone's response but had other issues requiring my attention. I have not checked any of the sensors. I assumed that I would get codes if those were the issue. I am starting back on this project and now find that the vehicle hard to start. Turns over fine but...
Runs fine when its runnning. Does not sputter at all. Does not matter if in drive or park, moving or not moving. No codes. Any ideas? Thanks for your help.
Through this code. Was gonna rebore the valve body but had lots of shavings so I purchased a GM rebuilt tranny with the torque converter and had it installed. 2 days later, same code. Any ideas? Obviously it's going back to the mechanic, just curious.
Brakes pump up slightly. Master cylinder was the first thing I replaced when this started. I guess it's possible I got a bad one. Could the ebcm be bad?
I realized I had only rebuilt wheel cylinders so I replaced them. Bled almost an entire bottle of brake fluid through the system. Adjusted rear shoes with drums off (no manual adj from the back on this Tahoe). Brake pedal comes up some but not much improvement. Any ideas?
Yes, everything at each wheel has been replaced. Even the hold down springs on the rear. I am getting no leakage anywhere. I do notice that the rear auto adjusters don't work very well, before or after they were replaced.
I can't locate the problem with a low brake pedal. Everything at the wheels has been replaced, master cylinder replaced, vacuum on power booster is good, lines bled, etc. Still get a low pedal have to push to the floor almost to stop. Any ideas?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.