tast101
Full Access Member
I'm going to install my radio soon. I'm not going to install my amps yet but I want to know can you guys provide some pic of your engine bay showing where you ran your power cable through the firewall into the cabin. Thanx
Amp power cable, Where to run it?
- Thread starter tast101
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
WrenchGuy
Full Access Member
- Joined
- Nov 11, 2007
- Messages
- 435
- Reaction score
- 0
The grommet to the right of the Brake Fluid container. I dont have a detailed pic. I wouldn't try anything bigger than 4 GA.
tann808
New Member
- Joined
- Jul 31, 2007
- Messages
- 47
- Reaction score
- 0
I ran my 0 gauge through there.
Gordo
Full Access Member
i ran mine under the left fender behind the fuse box, through a big hole in the fire wall that is sealed with a rubber gasket(easy to move) and then underneath the moldings on the driver side
WrenchGuy
Full Access Member
- Joined
- Nov 11, 2007
- Messages
- 435
- Reaction score
- 0
OK. It looked like you could. I just didn't consider running 1/0 through it. My bad.