i ean my 96 hoe to work thursday and when i got home left it in 4 whel drive hi,wife got into it friday and no 4 wheel drive,indicator does not light up and since it got hung up in our driveway no 4x4.anyone got any ideas what might have happened?i tried again today since it was above freezing thought maybe something had froze up but still nothing.any help would be appreciated
4 wheel drive help
- Thread starter mross
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
loulblades
Full Access Member
If there are no indicators at all, check the 4WD and Transfer Case fuses in the fuse panel on the driver's side of the I/P. The switch assembly, with the indicators, does go bad, I replaced mine within the last year.
loulblades
Full Access Member
If the indicators do not come on at all (even when you first turn the key on) then it sounds more like the TCCM. Try resetting it by pulling the Transfer Case fuse (or removing the - battery cable) for at least 30 seconds.
You can easily pop out the switch assembly from the dash and do continuity tests on the switches and test the indicators with a 12V source. If you get to that point I can get the pin numbers on the connector. The switches are inputs to the TCCM and the indicators are outputs.
If resetting the TCCM doesn't help you can refer to a document I posted in the Technical Info section on troubleshooting 4WD.
You can easily pop out the switch assembly from the dash and do continuity tests on the switches and test the indicators with a 12V source. If you get to that point I can get the pin numbers on the connector. The switches are inputs to the TCCM and the indicators are outputs.
If resetting the TCCM doesn't help you can refer to a document I posted in the Technical Info section on troubleshooting 4WD.