TahoeGoBoom
Full Access Member
Ok, so i just bypassed the amp, and it was quite easy. it took me about 15 minutes.
i clipped the wires, and capped the black and orange wires (power and ground). if you look at the plug you can see the wires come in pairs, these are the in and out if the speaker wires through the amp. the pairs are as follows:
light blue and blue
red and tan
brown and yellow
white and tan
now the fact that there are two tans can mess you up, but the tans are on separate sides of the amp, and if you pair the wire colors together, this wont be an issue.
then you strip the wires and connect them as follows:
Right rear:
red with light blue
tan with blue (this is the tan that pairs with the red wire)
Left rear:
white with brown
tan with yellow (this is the tan that pairs with the white wire)
now the amp is no longer used.
i clipped the wires, and capped the black and orange wires (power and ground). if you look at the plug you can see the wires come in pairs, these are the in and out if the speaker wires through the amp. the pairs are as follows:
light blue and blue
red and tan
brown and yellow
white and tan
now the fact that there are two tans can mess you up, but the tans are on separate sides of the amp, and if you pair the wire colors together, this wont be an issue.
then you strip the wires and connect them as follows:
Right rear:
red with light blue
tan with blue (this is the tan that pairs with the red wire)
Left rear:
white with brown
tan with yellow (this is the tan that pairs with the white wire)
now the amp is no longer used.