Recent content by Whipple1

Im having the same problem with my truck,same exact! still not sure what the fix is Im leaning toward it has to get reprogrammed by the dealer Tech2 ,Im going to try this soon!

Those are the symtoms of the intermediate shaft,there is a temp grease fix but will come back,the best fix is the new Borgeson shaft.

Yeah water leaks suck :mad3:, im not looking foward in doing this,the pic you took is good,You can see the seam seal thats under the kick panel in your pic,If you follow that all the way to the front corner and up toward the top of the dash,mine coming half way up between that seam,the black...

I had this same problem and thought I fixed it until today,I went to clean my floor mat and seen the bottom was wet again.I will have to dig a little deeper this time to fix the problem,My problem is coming from the driver side corner seam ,(its the vertical seam behind the e-brake connecting to...

The supercharger is the best upgrade Ive done to my truck,I had it on there for 5+ years now with no issues, knocking wood.The only downside is if your not in good with your dealer there can be a warranty issue if you blow the engine,but they still cant prove it,you just have to make sure the...

The way you are describing the symtoms it sounds like detonation(engine ping) that can give a rattle sound while excelerating and worse under a load,It will also under power the truck big time,Try putting some high octane fuel in,or go to autoparts store and get a bottle of octane boost (NOS...

Not to sure what your looking for, but you can try the link below im sure they can head you in the right direction http://www.suicidedoors.com/index.php

My buddy has a 22' Seahunt and his trailer has a seperate brakeing system and a flush setup for the axles,Dont all larger trailers have this?

The rain isnt a problem,I used it in heavy rain and drove on the parkway then checked inside the tube when I parked just a little water spray,the tube has to be 3ft long and is going up vertical for about 2 ft,I will make a block off plate when it snows out so it dont get loaded up,my main...

Sorry to hear about the fender bender,She will soon be good as new,When I changed my steering components,I used all Moog there are much heavier than stock,and I also changed my steering shaft to the Borgeson witch made a difference.

Hey JK good to be back,Its great to hear from ya,I've been busy at work and now I have been off for awhile,so from time to time I check to see whats goin on,Your set up looks sweet also,I guess that air box you have had a stem to connect the dryer hose to and I see its closed,keeping that hot...

I see everyone goin crazy over cold air intakes,how about getting that nice cool outside air forced into the CAI,I recently made a ram air for my intake and my supercharger is loving it:ura:,im sure it will work great on a NASP motor as well,also I tested this for awhile in real hot weather and...

Ok ,it does look a little different,But in your pic I see a large harness going into the truck,right under that control box,check to see if you can slice the top of that grommet.If you look at that second pic that looks like the same grommet I sliced.

There is a spot to get through the fire wall,remove (unclip) the black plastic box right next to the master cylinder you will see a large grommet,take a sharp razor knife a slice along the top of grommet,this is great for smaller wires and maybe a zero guage but going under to the rear sounds...

Congrats on your new ride,The things you mentioned above dont seem serious at all,I think replaceing leaky gaskets is a good idea,I think replaceing the intake manifold gasket would be the most important,replacing the injectors is not nessasary,although have the coil and injector checked of the...