I wouldn't try and shoehorn the Suburban seats in. You'll end up with numerous problems on this, from having seats sit too high to having bad looking floor treatments. Those velcro'd floor panels only have maybe 1/2" of clearance tops. Also, I'm not sure how you would mount the forward mounts...
All of the PPV's I have been in (and no I wasn't handcuffed) have had a smooth vinyl. I was at a Chevy dealer just today looking for a Cobalt and noticed that every Suburban, Tahoe and Silverado I saw with Ebony leather had the very coarse texture. Almost looked like Larry King's skin. Come...
I have not seen them side-by-side. The Tahoe metal seat bases are built for a stepped floor with a rise in the base of about 1.5" just ahead of the rear mounting holes. I suspect that is due to the frame accomodation for the rear axle. With the longer flat floor in the Suburban, it may not...
Yes, the material is different, but overall similar from a distance. The PPV 2nd row seats do not have a center fold down armrest. The PPV's come standard with cloth front buckets and 2nd row vinyl 60/40 and are only availalbe in Ebony. The 4x4 Special Service editions have more options, but...
First, I painted the Rivnut with three coats of paint with a detailing brush over several hours. Then, I put a small dab of silicone in the hole and inserted small plastic plugs I found at Lowe's. They fit very snug against the rivnut and sealed it well. After letting the silicone dry for a...
There is no single part number for the seats, they are a combination of different parts. Either way, dealer prices are around $1K per seat. Watch on eBay for the best deals, but they usually include the 2nd row seat.
Trying to just swap the covers is a task best left to an upholstery...
Not on the exterior surface on my Tahoe. It's just metal to metal and the bottom edge of the rivnut is serated, leaving small gaps between the surfaces. I sealed mine with several coats of paint. the other thing that surprised me was that the Rivnuts were installed after the body was painted...
A rubber well nut should work, although they tend to tear when they are subjected to a strong load. The factory installation features a riveted nut assembly with lips on the outside and inside of the roof skin. I was surprised at the lack of waterproof sealant on the factory installation. It...
For what its worth, GM calls the turn signal assembly a Turn Signal/Malfunction Switch. The TSM switch does not show up anywhere in the security wiring circuit.
I'm going to have to maybe go the other way on this now that I've tried it and think about it.
I can't get the thing to do what we're talking about, but I do recall a couple of times where I had the Tahoe out in the driveway (vacuuming, washing etc.) and had the horn make several short...
I suppose if that doesn't work, flash your lights 3 times, move the driver's seat forward or backward 2.5", turn the right rear dome light on and off 13 times in 10 seconds or less and deflate the left rear tire by exactly 3psi.
Are you guys yanking our chain in this? This seems really...
I monitor mine pretty closely and run in V4 a lot of the time. The two things that help the most are keeping your foot easy on the accelerator and having the transmission in tow/haul mode. It locks the torque converter for longer intervals and helps keep it in V4 above 45 unless you are on a...
Looking at my set, the rails consist of 4+ pieces per side plus crossbows. Each side has a metal frame and three attached plastic feet. Those feet are comprised of a top and a bottom that are assembled together and then snap onto the metal frame.
The metal frame has the following two...
Nnaboy has a good point, but its can be a trade off. As for me, when I started looking, I was determined to get a tahoe or suburban with ebony 2nd row captains. I bought my '07 LS very very cheap with 29K on it. I was patient and found my complete set of seats, center console and 3rd row (all...
The best place is eBay, but I have only ever found them packaged with the front seats. New from the dealer they are outrageous and walk out the door laughable.
I cannot stress enough that there are two very different types of ebony leather on these GM's. I still have not found a definitive...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.