Debadging Yukon

[turnerm12]

Whatsup I have a 03 Yukon and want to debadge the emblems. Wanted to know if anybody had any good methods. Thanks in advance!

 

[jgiguere17]

blow dryer, heat about 3 minutes or so, and I used fishing line to run against the paint and the emblem.

Then I used GooGone to clean up the rest of the residue that was left over after I pulled off the emblems and then some carnuba sealer and some wax to seal it up where the emblem was.

 

[Custom73]

I use the same method. Heat it until it's warm to the touch but not hot enough to burn your fingers. Saw behind it with fishing line or dental floss. A couple times I've had to use a little rubbing compound - could see a shadow of the emblem after the adhesive was removed. Little rub and some wax took care of it.

 

[DarkTahoe00]

X3

 

[cwyatt27]

could somebody please let me know how to post my own message? i have a couple questions on debadging my tahoe

 

[notch8]

I heated with a hair dryer and worked a credit card behind the emblem, then cleaned up with goo gone. The double sided tape is a pain, and it helps to roll it onto itself over just peeling it off. That can save time.

 

[Polecat]

could somebody please let me know how to post my own message? i have a couple questions on debadging my tahoe

back up one page, top left, New thread

 

[Polecat]

like mentioned, i used heat gun and 3M adhesive remover...