teamdime1011
New Member
- Joined
- Jul 4, 2008
- Messages
- 10
- Reaction score
- 0
lookin to hook up an ipod output to the back of my stock radio, i just dont know how to pull it out. suggestions are greatly appreciated.
how do you remove the radio?
- Thread starter teamdime1011
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
WrenchGuy
Full Access Member
- Joined
- Nov 11, 2007
- Messages
- 435
- Reaction score
- 0
Tilt Down put in 1st gear. Pop face trim off and remove 7mm screws around radio.
oneradride
Full Access Member
What year? Most of these do not require any tools at all. Pull off the trim plate the covers the forward most part of the driver dash area, shift into to lower gear to make it easier.
Once that’s off, push the 2 tabs, one on each side of the radio, straight down and pull the head unit towards you, away from the dash and you’re done, takes about 30 seconds.
Once that’s off, push the 2 tabs, one on each side of the radio, straight down and pull the head unit towards you, away from the dash and you’re done, takes about 30 seconds.
JKmotorsports
tahoeyukonforum.com
00-02 are secured with a clip on each side. 03-up are secured with screws.
