Remove the wheel hub and the 15-series bearing mounting bolts (4).
9. Remove the wheel hub and bearing (4) mounting bolts, 25/35 series.
10. Remove the wheel hub and bearing and splash shield from the vehicle.
11. Remove the O-ring seal from the steering knuckle bore, 25/35 series.
12. Remove the wheel speed sensor mounting bolt (5).
13. Clean and inspect the O-ring seal, 25/35 series.
14. Replace the seal if the following conditions exist:
o Nicks
o Cuts
o Dry or brittle
o Compression set
Installation Procedure
1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing assembly.
2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
3. Install the O-ring (7) to the steering knuckle, the 25/35 series. Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the wheel speed sensor mounting bolt to the wheel hub and bearing.
o Tighten the sensor mounting bolt to 18 Nm (13 ft. lbs.) .
5. Install the wheel hub and bearing and splash shield to the vehicle, 25/35 series.
6. Install the wheel hub and bearing (5) and splash shield (6) to the vehicle, 15 series.
7. Install the wheel hub and bearing mounting bolts, the 15 series.
8. Install the wheel hub and bearing mounting bolts, 25/35 series.
o Tighten the wheel hub to knuckle bolts to 180 Nm (133 ft. lbs.) .
9. Install the nut (2) and washer (3) retaining the wheel drive shaft assembly to the wheel hub and bearing.
o Tighten the nut to 240 Nm (177 ft. lbs.) .
10. Install the wheel speed sensor and brake hose mounting bracket bolt to the steering knuckle.
o Tighten the brake hose clip bolt to 12 Nm (106 inch lbs.) .
11. Install the rotor.
12. Install the tire and wheel.
13. Lower the vehicle.