I purchased a used kenwood DDX712 double din and the kenwood KNA G510 Garmin Gps.
Having never installed a double din before ...I'm hoping to get input as to what I think is correct.
I have attached a jpg of the kenwood harness.
A is the kenwood connection.
B are the speaker wires.
C are not needed (I think)
D is a Metra 14 wire male plug.
E I dont think are needed.
F are hot/ground/reverse/parking brake/etc
My problem is the Metra connection, I am going to cut it off and discard it.
The speaker wires on 'A' would then connect to my speakers.
Vehicle is a 1999 Yukon.
Is this a no brainer or am I missing something?
Any assist is appreciated.
Having never installed a double din before ...I'm hoping to get input as to what I think is correct.
I have attached a jpg of the kenwood harness.
A is the kenwood connection.
B are the speaker wires.
C are not needed (I think)
D is a Metra 14 wire male plug.
E I dont think are needed.
F are hot/ground/reverse/parking brake/etc
My problem is the Metra connection, I am going to cut it off and discard it.
The speaker wires on 'A' would then connect to my speakers.
Vehicle is a 1999 Yukon.
Is this a no brainer or am I missing something?
Any assist is appreciated.