hapyspaz
New Member
I just recently replaced my power window motor on the driver door of my 99 2-door, and as much fun as I had doing so, the fun isnt over yet.
Now that the motor is in place, wire looms connected, everything works great, except the fact that it is backwards. Down means up, up means down, and as cool as it is to have Auto-Up on the window, remembering to go the wrong direction on the switch isnt all that fun.
Any ideas? I assume that I can simply snip and cross the wires on the wire loom that came with the aftermarket motor, but I dont want to fry anything, and if there is a way to do this without having to pull the whole assembly off again it would be nice.
Now that the motor is in place, wire looms connected, everything works great, except the fact that it is backwards. Down means up, up means down, and as cool as it is to have Auto-Up on the window, remembering to go the wrong direction on the switch isnt all that fun.
Any ideas? I assume that I can simply snip and cross the wires on the wire loom that came with the aftermarket motor, but I dont want to fry anything, and if there is a way to do this without having to pull the whole assembly off again it would be nice.
