Recent content by hd_ryder

Owners with 2000-2006 models that have had issues with the rear hatch lock not working correctly, what problems did you find to correct? Thank you for the help

Where is the Fuse Location for the Rear Hatch electronic lock, 2006 Tahoe? I have looked in both under hood and passenger Fuse Box locations, but do not see it identified. I was able to find a manual release, but now need to trouble shoot the electrical issue. Thank you for the help.

2004-2006 Tahoe. Has anyone had a 'Tighten Fuel Cap' message that ends up creating a P0455 DTC, and tightening or replacing the cap does not correct the problem? Did you find your EVAP leak? So far I have replaced the Fuel Cap, vapor canister vent valve solenoid and attached hose, and vapor...

Has anyone had a large brake fluid leak at or near the ABS Modulator Valve, mounted on the LH frame rail below the driver, 2000-2006 Tahoe? So far I can't tell if it may be a rusted line at that location, or if the actual ABS Modulator Valve is leaking. Has anyone seen one leak before? Thank...

Both the Automatic Headlamp System and the Daytime Running Lamps (DRL) are not working on my 2006 Tahoe. I can turn the Headlamps on manually. I have replaced the dash mounted Ambient Light Sensor. All bulbs and sockets look in new condition. I have checked the DRL Fuse and swapped the DRL...

Does anyone know of a way to test if the Ambient Light Sensor is working correctly in a 2006 Tahoe?

I want to check the valve adjustment on my '99 Tahoe 5.7L. Are there any Timing Marks and Indicator on this engine? If not, how would I be able to locate TDC for cylinder #1? Thank you for the help on this one.

Does anyone have the procedure steps for removing the rear side door glass for a '94-'99 Tahoe? I am replacing the driver's side rear door with a better undamaged one, but the glass in my original door is in better shape, so I want to swap it out into the new door. I have removed and replaced...

I removed the door handle and tumbler, and it looks like the tumbler must not have been seated all the way into the hole cavity to have the spring loaded plunger seat properly. I have it now seated correctly, so it should now stay in place. Thank you for the help on this one!

The key tumbler keeps falling inside the door. It's hard to see up in there. I am pretty sure it started happening after I replaced the exterior handle a few years ago. What actually holds it into place? Thank you for the help on this.

Does anyone know what it would take to use 2000-2002 Tahoe (1999-2005 1500 Silverado) rear 6 lug single piston rear calipers for a '95-'99 Tahoe rear disc conversion? Is the rear end housing much different on the 2000-2002 models? Axles, etc.? Thanks for the help?

I just replaced both rear drums, all 4 shoes and new rear brake hardware. The passenger side is working great. The driver side is dragging and will get very hot in a very short time. On the driver side the front shoe is moving inward, toward the backing plate, when it is pushed out by the...

Before going on to the step of replacing the CKP sensor, I replaced the Duralast distributor cap and rotor button kit from AutoZone, which had a 5-year warranty. They were less than a year old, but I figured replacing them for free under warranty might not be a bad investment in my time. After...

Can the Crankshaft Position Sensor be replaced without pulling the crank pulleys?

Can a DIY mechanic perform the Crankshaft Position Sensor Variation Learning Procedure, or will I have to take it to the stealership to get that done? Thanks for the help.